Roofing Services in New Jersey

Monarch Roofing & Construction covers the full range of roof work for homes and commercial buildings across Bergen, Passaic, Essex, Hudson, and Morris counties, from new installations and replacements to targeted leak repair and storm restoration. See the areas we serve.

A full roof replacement removes the existing system down to the deck, inspects the decking, and installs new underlayment, flashing, and roofing material. New roof installation applies the same disciplined process to new construction and additions, with flashing and ventilation planned from the start.

Roof leaks often start away from where water appears inside. Our leak detection process traces moisture to its source, whether that is cracked shingles, failed flashing, or a worn seal, so the repair addresses the real cause rather than only the stain.

Asphalt shingle roofing suits most pitched residential roofs and is installed with attention to nailing pattern, underlayment, and ice-and-water protection at valleys and eaves. Flat roofing for commercial and low-slope buildings uses membrane systems installed over a prepared substrate, with seams and drainage checked throughout.

A roof inspection documents the condition of shingles, flashing, gutters, and ventilation without unnecessary disruption. After a storm, we assess wind lift, hail impact, and debris damage, then outline the repairs or replacement that protect the structure. We do not promise outcomes before we have looked at the roof. Leaks near a chimney often trace back to the flashing, which we cover under chimney repair and flashing.

Residential roofing focuses on the homeowner's priorities: appearance, drainage, and long-term protection. Commercial roofing addresses larger roof areas, rooftop access, drainage design, and scheduling that keeps building operations running. Both are handled by the same crew standards.

Every project follows the same sequence, so each stage is documented before the next one begins.

We inspect the roof, decking, flashing, and drainage to identify the actual condition and cause of any problem.

Old materials are removed as needed, and the substrate is repaired, dried, and checked before new layers go down.

Underlayment, membrane or shingles, and flashing are installed to the material manufacturer's requirements.

We review seams, edges, penetrations, and perimeter details, then walk the finished work with you.

Book a roof inspection and get a clear assessment of what your building needs next.